한국어

네트워킹

온누리070 플레이스토어 다운로드
    acrobits softphone
     온누리 070 카카오 프러스 친구추가온누리 070 카카오 프러스 친구추가친추
     카카오톡 채팅 상담 카카오톡 채팅 상담카톡
    
     라인상담
     라인으로 공유

     페북공유

   ◎위챗 : speedseoul


  
     PAYPAL
     
     PRICE
     

pixel.gif

    before pay call 0088 from app


http://www.pbxphreak.com/QoS/

 

 

Ernie's Quality of Service Guide

QoS Overview
"The ability to identify and prioritize specific applications, users, or data flows and guarantee a desired level of network performance"

  • Converged Networking: Voice, Video, Special Applications and Data

  • Quality of Service: Grade of Service and Mean Opinion Score

  • Factors: Throughput, Latency, Jitter and Loss

  • Features: Classification, Queuing, Congestion Avoidance, Policing, Rewriting and Scheduling

  • Layer 2 frames will identify "interesting" traffic by CoS in the Ethernet Header (Class of Service: 802.1p markings carried on an 802.1Q trunk)
    Valid values for CoS: 0 - 7

  • Layer 3 packets will identify "interesting" traffic by ToS in the IP Header (Type of Service: IP Precedence and DSCP aka DiffServ)
    Valid values for IP Precedence: 0 - 7
    Valid values for DSCP: 0 - 63

QoS Goals

  • Prioritize traffic to help ensure voice quality and call control are maintained
    - Guarantee bandwidth for voice during times of congestion (G.711 = ~90kbs/call and G.729 = ~32kbps/call)
    - Latency < 150ms (less than 80ms ideally) - In one direction (mouth to ear)
    - Jitter < 30ms
    - Packet Loss < 1%
  • Reduce latency and increase throughput for other specific applications such as video

QoS Strategy

  • Use CoS (Class of Service) and DSCP (DiffServ) to identify voice, video, control and specific applications frames and packets and ensure that this specially marked traffic is given the correct priority PHB (Per Hop Behavior) as an end-to-end (LAN and WAN) solution enterprise wide
  • Configure VoIP equipment to correctly mark voice traffic (RTP and Control) with specific CoS / DSCP values
  • Configure switch / router queues to move (and use policies to mark) frames and packets based on an agreed upon order and desired bandwidth

Network traffic will fit into one of these four (4) general categories in this strategy guide:

  1. Voice Traffic – Real-time conversations
  2. Control Traffic – Network (Spanning Tree), Inter-Network (Routing Protocols) and Voice (H.248 / MGCP)
  3. Priority Application Traffic – Video, Citrix, 3270 etc.
  4. Everything Else! – Email, Web, File Copy, FTP etc.
“Pre-set / agreed upon standards" - Ethernet Frame and IP Packet markings table

COS (Ethernet Frame)

DSCP (IP Packet)

Traffic

5

46

Voice Traffic (RTP)

3, 6, 7

26, 48, 56

Control Traffic (H.248 / MGCP)

4

34

Priority Application Traffic (Video)

0, 1, 2 (Unmarked)

0 (Unmarked)

All “Other” Traffic (Email, HTTP, FTP, SMB etc.)

  • Some telecom equipment is intelligent enough to correctly mark its own network traffic.
    If this is the case, you should configure the gear to mark based on the table above (Voice RTP = CoS 5 / DSCP 46 for example)
  • Other gear may need to rely on the Cisco switch or router to identify and mark frames and packets.
    ACLs, Class Maps and Policy Maps can use things like IP address, TCP / UDP port or the physical incoming switch port to mark traffic.
  • Simply marking traffic isn't enough. You will need to configure switches and routers to correctly queue and police ingress and egress ports based on the CoS / DSCP markings. During times of congestion, voice traffic should get special treatment and placed in the "front of the line" while other traffic like HTTP may get dropped! This is what QoS (Traffic Shaping) is all about.

Ernie's QoS Configuration Examples

Monitoring QoS

Tools

Selecting a Cisco Ethernet switch specifically for QoS

  • Cisco 2950 - Not desired, only has two (2) egress queues and no ingress QoS capability. (Has some basic QoS ability if you already own one.)
  • Cisco 2960 - Has POE and four (4) egress queues as well as can classify, reclassify, police, mark, queue, and schedule incoming packets.
  • Cisco 3560 - Optional POE, has great QoS support and the "Enhanced" image supports VRF-Lite.
  • Cisco 4500 Series - Modular "Campus" switch, optional POE and has great QoS support.
  • Cisco 6500 Series - Modular "Core" switch, optional POE and has full QoS support.

Additional QoS Related Reading & Links

Switching Methods

  • Cut Through - Forwards after looking at only the first 6 bytes. Could mistakenly forward a fragment, runt or damaged frame.
  • Fragment Free (Fast Forward) - Forwards after looking at only the first 64 bytes. Could mistakenly forward a damaged frame.
  • Store and Forward - Forwards after receiving and examining the entire frame. This was slower, but newer Cisco switches have very fast ASICs now.

Switching "Bus" Topologies

  • Shared Bus
  • Cross Bar

Buffering Configuration

  • Shared Memory
  • Port Buffered Memory
Queuing Methods
  • FIFO queuing
    This is the basic first-in, first-out queuing technique in which the first packet in the queue is the first packet that is processed. When queues become full, congestion occurs and incoming packets are dropped. FIFO relies on end systems to control congestion via congestion control mechanisms.
  • Priority queuing
    This technique uses multiple queues, but queues are serviced with different levels of priority, with the highest priority queues being serviced first. When congestion occurs, packets are dropped from lower-priority queues. The only problem with this method is that lower-priority queues may not get serviced at all if high-priority traffic is excessive. Packets are classified and placed into queues according to information in the packets. For example, Cisco routers can be programmed to prioritize traffic for a particular port into high-, medium-, or low-priority queues. Priority schemes may be abused by users or applications that mark packets with priorities that are not allowed. Admission control functions can monitor this.
  • Fair queuing
    This method helps solve the problem where some queues may not get serviced because high-priority queues are being serviced. A round-robin approach is used to service all queues in a fair way. This prevents any one source from overusing its share of network capacity. Problems can occur when packets are variable in length and each queue is allowed to release one packet at a time. Some queues will take more time. A byte-oriented scheme may be used to equalize the queues. In addition, some queues may be more full than others and naturally need more service, but a strict, fair queuing scheme will service each queue equally.
  • WFQ (weighted fair queuing)
    This can be seen as a combination of priority queuing and fair queuing. All queues are serviced so that none are starved, but some queues are serviced more than others. A weight is applied to queues to give some queues higher priority. For example, one queue may get half the available bandwidth and other queues will get an allocation of the remaining bandwidth. Traffic may be prioritized according to packet markings, source and destination IP address fields, port numbers, and information in the ToS field. WFQ weights traffic so that low-bandwidth traffic gets a fair level of priority. If high-priority queues are not in use, lower-priority traffic uses its queues. This prevents high-bandwidth traffic from grabbing an unfair share of resources. WFQ is Cisco's "premier queuing technique" according to the Cisco QoS paper listed on related entries page. A unique feature is that it moves real-time interactive traffic to the front of queues and fairly shares the remaining bandwidth among other flows.
  • CBQ (class-based queuing)
    CBQ is a class-based algorithm that schedules packets in queues and guarantees a certain transmission rate. If a queue is not in use, the bandwidth is made available to other queues. A CBQ-compliant device looks deep in packets to classify packets according to addresses, application type, protocol, URL, or other information. CBQ is more than a queuing scheme. It is also a QoS scheme that identifies different types of traffic and queues the traffic according to predefined parameters.

Terminology & Definitions

  • CBWFQ - Class Based Weighted Fair Queuing
  • COS
  • DiffServ
  • IP Precedence
  • LLQ - Low-Latency Queuing
  • PQ - Priority Queuing
  • Strict Queue
  • WRED - Weighted Random Early Detection

Other worthwhile reading (not specifically QoS related)

조회 수 :
75109
등록일 :
2012.01.06
01:11:08 (*.160.42.233)
엮인글 :
http://www.webs.co.kr/index.php?document_srl=680&act=trackback&key=625
게시글 주소 :
http://www.webs.co.kr/index.php?document_srl=680
List of Articles
번호 제목 글쓴이 조회 수 추천 수 날짜
34 a b c class Subnet Mask Cheat Sheet admin 21773   2019-10-16
 
33 Apple 소프트웨어 제품에서 사용하는 TCP 및 UDP 포트 admin 30871   2019-04-19
 
32 windows linux whois ip domain 도메인 아이피 소유자 확인 명령어 admin 139670   2019-02-16
 
31 route 및 iptables를 이용한 리눅스 특정 IP 접속 차단하는 법 admin 24017   2018-04-15
 
30 IPv6와 IPv4의 차이점 기존의 IPv4의 문제점 admin 20192   2018-04-15
 
29 사례를 통해 알아가는 실전 패킷분석 A 기업의 UDP 트래픽 급증의 원인은 admin 15385   2018-04-15
 
28 리눅스 linux 현재 사용중인 랜카드 트래픽 대역폭 확인 프로그램 nload admin 35406   2017-11-04
 
27 whois site ip owner check admin 21264   2015-08-03
 
26 TCP flag(URG, ACK, PSH, RST, SYN, FIN) admin 90807   2014-04-05
 
25 ping 핑 에 의한 패킷 전송 10 단계 그림으로 설명 file admin 38471   2014-02-13
 
24 Cisco - CCNP, CCIE - QoS. Quality Of Service admin 80922   2013-08-29
 
23 Securing Networks Access List Implementation on Cisco Routers admin 201013   2013-08-02
 
22 Analyzing High CPU Utilization Issues on Cisco Catalyst 6500 Series admin 36311   2013-08-01
 
21 ping 설명 ICMP Internet Control Message Protocol 설명 여러가지 admin 134059   2013-05-09
 
20 네트웍을 공부하려고 하는분 네이버 네트워크 전문가 따라 잡기 카페 admin 85445   2013-04-20
 
19 List of TCP and UDP port numbers admin 89091   2013-04-16
 
18 3com tftp damon program 3cdv2r10 file admin 32861   2013-03-17
 
17 VLAN Tagging - Understanding VLANs Ethernet Frames admin 103691   2013-03-11
 
16 Cisco Catalyst Fixed Configuration Layer 2 and Layer 3 Switches admin 53057   2013-01-30
 
» Quality of Service Guide - QOS admin 75109   2012-01-06
http://www.pbxphreak.com/QoS/ Ernie's Quality of Service Guide QoS Overview "The ability to identify and prioritize specific applications, users, or data flows and guarantee a desired level of network...  
14 IP Precedence, TOS & DSCP admin 88543   2012-01-06
 
13 [Cisco] NAT Config 해설 admin 297464   2011-12-19
 
12 트래픽관리를 위한 MRTG 서버구축 admin 41730   2011-12-16
 
11 Brocade FastIron GS Series manuall file admin 143616   2011-12-16
 
10 CAT.6 UTP 케이블링 작업 요령 file admin 41911   2011-12-16
 
9 윈도우에서 특정아이피 차단 설정 하기 admin 45457   2011-12-16
 
8 GRE Tunnel /VPN admin 35825   2011-12-16
 
7 VLAN과 TRUNK admin 33172   2011-12-16
 
6 와룡의 네트워크 카페에서 라우팅 ,스위칭공부 admin 38210   2011-12-16
 
5 방화벽 자료 admin 32989   2011-12-16